|
Product
Mirror Demister - The only solution for fogged-up mirrors
Installation Instructions
 A) Take a power feed from a light circuit or separate electrical circuit to exit wall where the mirror and demister are to be mounted. We recommend connection be made in flush-box.
B) Staple demister to the wall, making sure it is completely flat. Connect demister wire to electrical circuit, using a strip connector.
 C) Adjust the cable coming from the wall to line up with the cable coming from the demister , so that the connection does not protrude from the wall.
D) The mirror can be screwed, glued or mounted in a frame directly over top of the demister. We recommend that the demister be in contact with the mirror. (Note: DO NOT screw through element).
 Helpful TIPS:
-
If mirror being installed is to be screwed into position, using holes in glass, DO NOT over-tighten screws. We recommend screws be finger tight and then released half a turn (DO NOT use powered screw driver for mirror installation). This ensures that there is no tension in the glass.
-
If gluing or taping demister or mirror to the wall, we recommend the following:
Demister - a hand applicated, transfer adhesive tape i.e sellotape code 465
Mirror - a double-sided 3mm foam tape (available from most Glaziers) plus use a standard panel-board glue i.e MaxBond or NoMoreNails
If wall has a bend or bow, we recommend mirror to be packed evenly from wall, as opposed to "bending" mirror around the wall.
| 
